Back to Safe Working Practices main page
1. Introduction
Working in airports exposes you to a wide range of hazards, many of which are unique to this area of customs activities. There are many things which you need to consider to make sure you can work safely and avoid hurting yourself, or other people, at all locations handling air traffic.
This section groups the hazards under two main headings:
- Airside environment:
- working on tarmac;
- working on aircraft.
Usually you will receive specific training before working airside (i.e. on or near aircraft). This is because there are specific hazards and what you do could affect not only your own safety but also the safety of the aircraft and of the people travelling on it. Drivers will also be required to take an additional eyesight test (concentrating on colour differentiation between red and green).
2. Working on the tarmac
What are the hazards?
The most serious hazards associated with working in airports are encountered on the tarmac, which you should not work on or cross unless absolutely necessary. Find out if you need the prior authorisation of the airport operator — for example, in manoeuvring areas. You should follow local safety guidelines and be particularly aware of the following hazards:
Hazard: Moving aircraft
| |
Countermeasures:
| |
Hazard: Moving vehicles Many other types of vehicles could be present on the tarmac, such as:
| |
Countermeasures:
| |
Hazard: Aircraft engines and propellers
| |
Countermeasures:
Remember: NEVER walk near an aircraft while its engines are running. | |
Hazard: Helicopter rotors
| |||||||
Countermeasures:
| |||||||
Hazard: Aircraft noise
| |
Countermeasures:
| |
Hazard: General hazards
| |
Countermeasures:
|
3. Working on aircraft
Usually you should not have to inspect cargo or take samples on an aircraft, but if you do, always make sure that the pilot, ground crew and any other operatives in the vicinity know what you intend to do.
3.1 Gaining access
Access inside an aircraft
- Use the steps or air-bridge corridors provided for passengers or air crew, provided you are sure that they are secure.
- Take care as they could be slippery or wet.
- With some smaller aircraft you may be able to climb directly on board, but you should always follow the marked route, e.g. if access is across the wing.
- You should not use portable ladders.
Access the cargo hold of aircraft
- Follow the procedures laid down for baggage- and cargo-handlers.
- This might mean riding on vehicles with cargo-lifts or conveyors.
- Follow the guidance and safe working practices for cargo-handling staff.
- Take extra care if you are unfamiliar with the equipment being used or the procedures.
- If you are working on or near the aircraft when baggage or goods are being unloaded, take additional care as items may have moved during the flight and fall unexpectedly.
- Bags or packages may also fall off conveyors or handling equipment.
3.2 Working on board
Several hazards are common to all areas of aircraft.
- Insects are very resilient and can be found almost anywhere.
- Rats have been found in holds.
- Soiled tissues or other items can be dropped by people in all areas and should not be touched without gloves.
Aircraft equipment:
- Never attempt to examine any equipment on board until you have consulted a responsible official of the airline.
- Unskilled interference with safety equipment, navigational apparatus or electrical systems can affect the airworthiness of the aircraft, jeopardising the safety of the passengers and crew.
- You would be committing a criminal offence.
Passenger areas:
- When searching seating areas, be wary of sharp objects which may be secreted in the upholstery.
- If you remove anything from under the seat, e.g. lifejackets, you must ensure it is replaced correctly for use in an emergency. If in doubt inform the crew that it has been moved.
- Do not stand on seat arms to examine other areas.
Overhead bins and stowage:
- Beware of things falling onto your head.
- The protective lip on some bins can be used to conceal things. Look first.
Toilets:
- As well as presenting potential health hazards, in the form of discarded hypodermic needles, etc., toilets might contain corrosive cleaning chemicals and disinfectants.
- If you need to search these areas, wear appropriate safety clothing and equipment, particularly gloves, and wash your hands immediately afterwards.
Galleys:
- Electrical cooking equipment may operate at high voltages and could be very hot.
- Beware of broken glass, etc. in rubbish bags and bins.
- Galley lifts (when fitted) are particularly dangerous and should not be used to gain access.
Holds:
- Hold floors can be thin. Be careful where you place your feet.
- Avoid the many tripping hazards (drive wheels, roller beds, etc.).
- Wear a safety helmet, particularly if headroom is restricted.
Remember: refer to your national legislation and guidance when working in this dangerous environment.
You must refer to the legislation and the guidance of your national administration for more information.
The guidance contained in this section intended to serve as a general reminder of the risks that are sometimes encountered during the examination and sampling procedure and of the safety equipment that you should use and precautions that you should take.